|
Scott Wilkinson Thomas Norton Fred Manteghian Kim Wilson HT Geeks The Movie Room Ultimate Demos Recently Added
Video Displays
Speakers
Sources
Electronics
Accessories Features Audio/Video News CES 2010 CEDIA 2009 CES 2009 CEDIA 2008 CES 2008 CEDIA 2007 HE 2007 CES 2007 CEDIA 2006 HE 2006 CES 2006 Thomas J. Norton Michael Fremer Joel Brinkley Scott Wilkinson AV Links Contact Us Flatscreen TVs LCD TVs Plasma TVs HDTV AV Receivers Home Theater in a Box Digital Projectors DLP Projectors Video Projectors Surround Sound Dolby 5.1 |
RBH Signature Series surround speaker system:
The RBH 1266-SE's sensitivity measured approximately 88dB/W/m, and its ported cabinet is tuned to approximately 27Hz. Its minimum impedance is 3.4ohms at 300Hz; I rate the nominal impedance at 6ohms. Overall, the speaker should be of average difficulty to drive. The 1266-SE's pseudo-anechoic response at tweeter height, averaged over a 30° forward horizontal angle and combined with the nearfield responses of the woofer and port, is shown in Fig.1 (violet). The useful bass extends down to about 30Hz (-10dB relative to the output at 55Hz). The on-axis response is very smooth, but does show a rising trend toward the midrange and treble—or, looked at another way, there's a slight leanness through the mid- to upper bass and lower midrange. This is consistent with the listening results: not as warm-sounding as some speakers and perhaps a "little brash," leaning toward "the fast and slightly spotlit"—but (to paraphrase MF) clear and detailed without unnatural etch, edginess, or harshness. The wide off-axis response tracks the on-axis average very well, differing mainly in the typical off-axis high-frequency rolloff. Fig. 1 Fig.2 again shows the 1266-SE's averaged horizontal front response (violet), plus the vertical responses taken at +15° (red) and -15° (blue) relative to the tweeter. The response is, if anything, a bit flatter at modest angles above and below the tweeter than directly on-axis. Fig.2 The cabinet of the 661-SE center-channel speaker is tuned to about 52Hz. I rate its nominal impedance at 6ohms; the minimum impedance was 4.1ohms at 172Hz. The speaker's sensitivity measured approximately 90dB/W/m. It appears to be of average difficulty to drive. The 661-SE's averaged front horizontal response when used in the typical horizontal center-channel configuration, and taken in the same manner as described above for the 1266-SE, is shown in Fig.3 (violet). Here the port was closed, as MF used it in the listening tests; opening the port added a +4dB peak at about 85Hz. The useful bass extension is approximately 45Hz (-10dB relative to the output at 80Hz). The on-axis response is a little less smooth than the 1266-SE's. The wide off-axis response shows the same deep suckout we see in every woofer-tweeter-woofer center-channel speaker we've ever measured (the dip here appears to come from combing effects between the two woofers). But up to about 15° off-axis (not shown)—about the width of a typical three-seat couch 10 feet or so from the speakers—the response tracks the on-axis curve very closely, except for a narrow dip centered at around 3.5kHz and reaching a maximum of -5dB. The latter clearly comes from off-axis interference between the woofers and the tweeter. Fig.3 Fig.4 The 661-SE's ±15° vertical off-axis performance (Fig.4) is good, with the above- and below-tweeter responses nearly identical. —Thomas J. Norton
|
|
|||||||||||||||||||||||||||||||||||||||||||||
